Allied Telesis AT-S63 - Manual (Page 43)

AT-S63 Management Software Menus User’s Guide
Section I: Basic Operations 43
Configuring the Console Startup Mode
With this procedure you can control which management interface, menus
or command line, is displayed at the start of your local and remote
management sessions. The default is the command line interface.
To change the console startup mode, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 2 on page 31.
2. From the System Administration menu, type 3 to select Console
(Serial/Telnet) Configuration.
The Console (Serial/Telnet) Configuration menu is shown in Figure 8.
Figure 8. Console (Serial/Telnet) Configuration Menu
3. Type 1 to toggle Console Startup Mode between Menu and CLI. When
the mode is set to Menu, management sessions start with the Main
Menu. When the mode is set to CLI, management sessions start with
the command line interface prompt. The default is CLI.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
A change to the console startup mode takes effect the next time you
start a local management session.
Allied Telesis AT-9424Ts - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2009
Console (Serial/Telnet) Configuration
1 - Console Startup Mode ............ CLI
2 - Console Disconnect Interval ..... 10 minute(s)
3 - Console Baud Rate ............... 9600
4 - Telnet Server ................... Enabled
5 - Telnet insert NULL .............. OFF
R - Return to Previous Menu
Enter your selection?