Allied Telesis x610 Series Layer 3 - Manual (Page 88)

Chapter 3: Installing the Hardware
88
VCStack Stacking Module Installation
Overview
When you are preparing the x610 switches for a VCStack configuration, a
VCStack stacking module must be installed in the expansion slot on the
rear panel of the unit. Two VCStack stacking modules are available:
 The AT-StackXG, shown in Figure 56, has two full-duplex, 12 Gbps
stacking ports.
 The AT-x6EM/XS2, shown in Figure 57, has two 10 Gbps SFP+
stacking slots.
1240
AT-LX44CPU
CVR
AT-StackXG
Stac k Port 1
Stack Po
rt 2
2216
AT-LX44CPU
CVR
POW
AT-x6EM/XS2
1
2 L/A
L/A
SFP+
SFP+ CLASS 1 LASER PRODUCT
10G LINK
ACT
L/A
Figure 56. AT-StackXG Stacking Module
Figure 57. AT-x6EM/XS2 Stacking Module
Note that if the x610 switch is to be part of mixed-mode VCStack an