beautypg.com

Switch initialization messages (continued) – Allied Telesis 8100S Series User Manual

Page 96

background image

Chapter 6: Powering On and Verifying the Stack

96

Figure 40. Switch Initialization Messages (Continued)

At this point, the stack is operational and ready to forward network traffic.
Before connecting the network cables, go to “Verifying the Installation” on
page 101.

Note

After the stack becomes operational, the stack ID LEDs on the
master and member switches flash the ID numbers and code letter
“H” every few seconds. This is normal for the LEDs when the
switches are operating in a stack configuration.

Stack topology discovery is in process... Please Wait
Loading configuration file “boot.cfg” .... done!
Sending Configuration file to all slaves. Please wait...
00000001
Sending configuration file done!

Press key to connect...
New Switch 2 (00:15:77:99:99:91) is added into stack