Allied Telesis 8100S Series - Manual (Page 113)

Stack Installation Guide for 8100S Series Switches
113
The slot ID value, which is used to specify slot numbers in a multi-module
chassis, does not apply to 8100S Series switches and should always be 0.
The third value is a port number on the switch. You may specify one port
number in a PORT parameter, but you may specify more than one PORT
parameter in many of the commands that support the parameter.
Here is an example of the PORT parameter. It uses the INTERFACE
command to enter the Port Interface mode for ports 15 and 17 on the
switch with the stack ID 1:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15,port1.0.17
In this example, the INTERFACE command enters the Port Interface
mode for ports 1 to 18 on the switch with the stack ID 3:
awplus> enable
awplus# configure terminal
awplus(config)# interface port3.0.1-port3.0.18
For instructions on the command line interface and the PORT parameter,
refer to the AT-8100 Series AlliedWare Plus Command Line Interface
User’s Guide.