Allied Telesis 8100S Series - Manual (Page 72)

Chapter 4: Installing and Labeling the Switches in an Equipment Rack
72
Installing the Switches in an Equipment Rack
This procedure requires the following items:
 Eight bracket screws (included with the switch)
 Two equipment rack brackets (included with the switch)
 Flat-head screwdriver (not provided)
 Cross-head screwdriver (not provided)
 Four standard equipment rack screws (not provided)
Perform this procedure to install the switch in a 19-inch equipment rack,
Caution
The chassis may be heavy and awkward to lift. Allied Telesis
recommends that you get assistance when mounting the chassis in
an equipment rack.
 E28
1. Place the unit upside down on a level, secure surface.
Figure 21. Turning the Switch Upside Down
2. Using a flat-head screwdriver, pry the rubber feet from the bottom of
the switch.
Figure 22. Removing the Rubber Feet
3. Turn the switch over.