Allied Telesis 8100S Series - Manual (Page 74)

Chapter 4: Installing and Labeling the Switches in an Equipment Rack
74
Figure 24. Attaching the Brackets to Install the Switch in an Equipment
Rack (Continued)
The AT-8100S/24C Switch comes with two short brackets and one
long bracket. To install the device in an equipment rack, use one of the
short brackets and the long bracket. Allied Telesis recommends
installing the short bracket on the right side and the long bracket on the
left side, as you face the front of the unit, so that the stacking ports on
the unit align with the same ports on other 8100S Series switches in
the equipment rack. The possible positions of the brackets are shown
in Figure 25 here and Figure 26 on page 75.
Figure 25. Attaching the Brackets to the AT-8100S/24C Switch to Install
the Switch in an Equipment Rack