Allied Telesis 8100S Series - Manual (Page 83)

Stack Installation Guide for 8100S Series Switches
83
Figure 30. Connecting the Management Cable to the RJ-45 Terminal Port
on the Switch
2. Connect the other end of the cable to an RS-232 port on a terminal or
a personal computer with a terminal emulation program.
3. Configure the terminal or terminal emulation program as follows:
 Baud rate: Default is 9600 bps (Range is 9600 to 115200 bps)
 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. Press Enter.
5. When prompted for a user name, go to “Changing the Stack ID
Number” on page 85.
Starting a Telnet
Management
Session
Setting the stack ID number from a Telnet management session requires
Telnet client software on your computer. This procedure assumes that you
will be connecting your computer to a twisted pair port on the switch. To
start a Telnet management session on the switch using the factory IP
address:
1. Assign your management workstation the IP address 169.254.n.n, with
the subnet mask 255.255.0.0. The variable n can be from 1 to 255.
You may not use the switch’s IP address 169.254.1.1. Refer to your
computer’s documentation for instructions on how to set the IP
address.