Allied Telesis 8100S Series - Manual (Page 17)

17
Chapter 1
Overview
This chapter contains the following sections:
 “Features” on page 18
 “8100S Twisted Pair Series Switches” on page 21
 “8100S Fiber Optic Series Switches” on page 23
 “Back Panel Components” on page 26
 “Management Panel” on page 27
 “Model Naming Conventions” on page 28
 “10/100Base-TX Twisted Pair Ports” on page 30
 “10/100/1000Base-T Twisted Pair Ports” on page 32
 “SFP Slots” on page 34
 “Power Over Ethernet” on page 35
 “S1 and S2 Stacking Ports” on page 39
 “eco-friendly Button” on page 40
 “LEDs” on page 41
 “Console Port” on page 47
 “Power Supplies” on page 48
 “Power Connectors” on page 49
Note
This guide contains instructions on how to install the 8100S Series
switches in a stack configuration with the S1 and S2 stacking ports.
For instructions on how to install the switches as stand-alone units,
refer to the Stand-alone Switch Installation Guide for 8100L and
8100S Series Switches.
Note
This guide does not include the AT-8100S/48 and AT-8100S/48POE
Switches. The initial release of the management software supports
the 48-port switches as stand-alone units, but not in a stack. For
further information, contact your Allied Telesis representative.