Allied Telesis 8100S Series - Manual (Page 80)

Chapter 5: Assigning the Stack ID Numbers and Cabling the Stacking Ports
80
Powering on a Switch
Power on one of the switches in the stack with these instructions.
1. Plug the power cord into the AC power connector on the back panel of
the unit (see Figure 29).
Note
If you are installing a DC powered switch, refer to “Powering On DC
Switches” on page 97.
Warning
Power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.
 E3
Warning
This unit might have more than one power cord. To reduce the risk
of electric shock, disconnect all power cords before servicing the
unit.
 E30
Figure 29. Connecting the AC Power Cord