Allied Telesis 8100S Series - Manual (Page 28)

Chapter 1: Overview
28
Model Naming Conventions
The letters and numbers in the model names identify the hardware
features of the switches. The naming conventions for the twisted pair
8100S Series switches are identified in Figure 8.
Figure 8. Model Naming Conventions for the Twisted Pair 8100S Series
Switches
The conventions are defined in Table 4.
The letter “C” in the AT-8100S/24C model name denotes that the unit,
which has just one power supply, is smaller and more compact than the
other models.
The model naming conventions for the fiber optic 8100S Series switches
are identified in Figure 9.
Figure 9. Model Naming Conventions of the Fiber Optic 8100S Series
Table 4. Model Naming Conventions for the Twisted Pair 8100L and
8100S Series Switches
Convention Definition
1 This is the product name.
2 The letter “S” indicates that the model is stackable.
The letter “L” indicates that the model is not stackable.
(The non-stackable switches are not described in this
manual. For installation instructions, refer to the
Stand-alone Switch Installation Guide for 8100L and
8100S Series Switches.)
3 This is the number of 10/100Base-TX ports.
4 The letters “POE” indicate support for Power over
Ethernet.