Tables – Campbell Scientific EC155 CO2 and H2O Closed-Path Gas Analyzer and EC100 Electronics with Optional CSAT3A 3D Sonic Anemometer User Manual
Page 9
Table of Contents
6-2. EC100 enclosure mounting bracket mounted on a vertical mast
(left) and a tripod leg (right) ........................................................... 10
6-3. Exploded view of mounting the EC100 enclosure ............................. 11
6-4. End views of the analyzer showing the sample intake (optional
heated intake not shown), pump outlet, and zero-and-span
6-5. EC100 electronics front panel. The picture on the left shows the
panel as it is shipped from the factory (enhanced barometer
shown). The picture on the right shows the panel after the user
has done all the wiring and made all connections (basic
barometer used). ............................................................................. 14
6-6. Bottom of EC100 enclosure ............................................................... 15
7-1. The Main window of ECMon ............................................................ 21
7-2. The Setup window in ECMon ............................................................ 22
7-3. The ECMon Status window ............................................................... 22
8-1. An example of USB data output in terminal mode ............................ 25
9-1. The underside of the optional heated intake ....................................... 28
9-2. The EC155 analyzer with the top shell open ...................................... 29
9-3. By loosening the thumbscrews above the sample cell, the latches
may be spun from position A to position B, thus freeing the
struts of the analyzer. ...................................................................... 29
9-4. The EC155 analyzer and sample cell with shell top open .................. 30
9-5. Analyzer removed from sample cell and shell ................................... 30
9-6. ECMon Zero/Span window ................................................................ 34
9-7. Replacing the source housing desiccant/scrubber bottle .................... 35
9-8. Replacing the detector housing desiccant/scrubber bottle .................. 36
A-1. Frequency and amplitude response of the EC100 filter at various
bandwidths ................................................................................... A-2
A-2. Frequency response comparison of the EC100 10-Hz bandwidth
and a 50-msec moving average .................................................... A-3
Tables
6-1. EC100 SDM output to a Campbell Scientific CR1000, CR3000,
or CR5000 Datalogger .................................................................... 16
8-1. USB and RS-485 Output Elements .................................................... 25
8-2. Multipliers and Offsets for Analog Outputs ....................................... 26
10-1. Output Modes for EC100 Instruction ................................................. 38
10-2. Bits in the Sonic Diagnostic Flag ....................................................... 38
10-3. Bits in the Gas Diagnostic Flag .......................................................... 39
10-4. ConfigCmd Values for Setting and Retrieving Settings ..................... 41
A-1. Filter Time Delays for Various Bandwidths ................................... A-3
iii