I i i i i, I nf i, 3 module 3 - l – Red Lion P16 User Manual
Page 15: 1 i, Ockout, Arameters, Sp pid op al code spsl, Sprp trnf tune alrs cnfp
15
2
ANALOG OUTPUT RANGE (OPTIONAL)
1
V
2
mA
2
mA
Select the type of output and range. The Analog output jumpers are factory
set to current. They must be changed if voltage output is desired. The Analog
output can be calibrated to provide up to approximately 5% over range
operation (0 mA current can only go slightly negative).
ANALOG UPDATE TIME (OPTIONAL)
to
2
seconds
=
update rate of 0.1 second
The update time of the Analog Output can be used to reduce excess valve
actuator or pen recorder activity.
ACCESS CODE
12
to
12
I
I
I
I
I
The following parameters can be configured for
,
I
,
and
I
.
I
nF
I
The following parameters can be configured for
or
I
only
.
ANALOG OUTPUT ASSIGNMENT (OPTIONAL)
This setting selects the parameter that the Analog Output will retransmit or
track.
ANALOG LOW SCALING (OPTIONAL)
-999
to
9999
The Analog Output assignment value that corresponds to 0 V, 0 mA or 4 mA
output as selected.
ANALOG HIGH SCALING (OPTIONAL)
-999
to
9999
The Analog Output assignment value that corresponds to 10 V or 20 mA
output as selected. An inverse acting output can be achieved by reversing the
low and high scaling points.
7.3 module 3 - l
oCKout
p
ArAmeterS
(
3-LC
)
SP
PId
OP
AL
CodE
SPSL
SETPOINT
ACCESS
OUTPUT
POWER
PID
VALUES
SETPOINT
SELECT
3-LC
ACCESS
CODE
ACCESS
ACCESS
VALUES
ALARM
ACCESS
ACCESS
SPrP
trnF
tUNE
ALrS
CNFP
A
A
SETPOINT
RAMP
ACCESS
CONTROL
TRANSFER
ACCESS
AUTO-TUNE
START
ACCESS
RESET
ALARMS
ACCESS
PARAMETER MENU
1
I
In
Active Setpoint
SETPOINT
ACCESS
OUTPUT
POWER
ACCESS
PID VALUES
ACCESS
ALARM
VALUES
ACCESS
SETPOINT
SELECT
ACCESS
AUTO-TUNE
START
ACCESS
SETPOINT
RAMP
ACCESS
CONTROL
TRANSFER
ACCESS
RESET
ALARMS
ACCESS
Input Signal Retransmission
Main Control % Output Power
SELECTION
DESCRIPTION
I
Display: accessible in Display Loop.
I
Hide: accessible in Hidden Loop.
Locked: not accessible in either loop.
(SP only)
Display/read: read only in Display Loop,
but read/write in Hidden Loop.
Full access to Display, Hidden,
and Configuration Loops
1
to
12
Code necessary to access
Configuration Loop only.
1
to
12
Code necessary to access
Hidden and Configuration Loops.