beautypg.com

Special alarms, Setting alarms – DAVIS Vantage Vue Wireless Console Manual User Manual

Page 36

background image

Alarm Mode

32

Vantage Vue Alarms

Special Alarms

ET (Evapotranspiration) (Optional)

Note:

The ET Alarm is only available when the console is receiving data from a Vantage Pro2 Plus

or Vantage Pro2 with solar radiation sensor. If your Vantage Vue console is not “listening to”
a Vantage Pro2 Plus ISS, you cannot set an ET alarm.

ET is updated once an hour, on the hour. If during a given hour the ET value exceeds the alarm
threshold, the ET alarm sounds at the end of that hour. This is true for daily, monthly, and
yearly ET alarms. See “Evapotranspiration (ET)” on page 46 for a description of this variable.

Barometric Pressure
The Vantage Vue allows you to set two barometric pressure alarms: a “rise” alarm and a “fall”
alarm. You may select any rate of change per three hours between 0.00 and 0.25 inches (6.35
mm) Hg, (8.5 mb, hPa). The alarm will sound if the rate of change (in either direction) exceeds
the threshold you set. This alarm is updated every minute.

Setting Alarms

1. Press and release 2ND then press ALARM to enter the Alarm Mode

to view or set the high alarm thresholds. The screen displays the
current high alarm thresholds. The

icon displays and “HIGH ALARMS” displays in

the Weather Center.

Variable

Alarms

Barometric Pressure Trend

Storm Warning - uses trend value falling rate
Storm Clearing - uses trend value rising rate

Evapotranspiration*

ET Alarm - uses total ET for the day

Humidity, Inside

High and Low

Humidity, Outside

High and Low

Dew Point

High and Low

Rain

Flash Flood Alarm - uses current 15 minute rainfall
total
24 Hour Rain Alarm - uses current 24 hour rainfall total

Storm

Storm Alarm - uses current storm rainfall total

Rain Rate

High

Inside Temperature

High and Low

Outside Temperature

High and Low

Heat Index Temperature

High

Wind Chill Temperature

Low

Wind Speed

High and 10-Minute Average

Time & Date

The alarm sounds for 1 minute.

*Evapotranspiration measurements are only available when receiving data from Vantage
Pro2 Plus stations or other Vantage Pro2 ISS stations in which a solar radiation sensor
has been installed.