DAVIS Vantage Vue Wireless Console Manual - Manual (Page 19)

Current Weather Mode
15
1. Press the + and - keys to select the baud
rate.
Your Vantage Vue console supports baud
rates of 1200, 2400, 4800, 9600, 14400,
and 19200.
2. Press DONE to save the baud rate settings.
Exiting Setup Mode
You have successfully completed all the screens in the Setup Mode. To exit Setup Mode, press
and hold DONE for several seconds until the Current Weather screen appears.
Clear All Command
After you have completed the above set up procedures and have exited the Setup Mode and
once the Vantage Vue ISS, Vantage Pro2 ISS or Anemometer Transmitter kit has been
installed, use the Clear All command before putting your weather station into service.
The Clear All command clears all stored high and low weather data including monthly and
yearly highs and lows, and clears the alarm settings. The command is recommended to
properly clear the console of any erroneous data when first putting your station into use.
1. Press WIND to display wind speed on the console.
2. Press 2ND, then press and hold CLEAR for at least six seconds.
3. Release CLEAR when you see “CLEARING NOW” displayed at the bottom of the
console’s screen.
Current Weather Mode
In the Current Weather Mode you can display the current data readings from your station,
select units of measure, and calibrate, set, or clear weather variables.
You can see up to eight weather
variables on the screen at the same time,
as well as the time and date, moon phase
and forecast icons, and a graph of the
currently selected variable.
Some variables are always visible on the
console screen while most variables
share their location with one or more
variables. You can select any variable
not currently on the screen to display it.
N
S
W E
NE
SE
NW
SW
WIND
am
INSIDE OUTSIDE
RAIN RATE CHILL
in/hr
F F
F
in