DAVIS Solar Power Kits (6612, 6614) - Manual (Page 7)

6
7. On the back wall of the shelter, look for the embossed outline of a Vantage
Pro2 console and the screw holes marked “VP2.”
8. Insert the two ½'' #6 screws into the marked holes. The depth of the hole has
been specifically designed so that the screw will “bottom out” at the correct
depth. Do not overtighten.
Note: You may need to adjust the screw height for proper fit.
9. Point the console’s antenna down and push the kickstand back to its locked
position. Guide the two keyholes on the back of the console over the two
screws and pull the console downward to lock in place. (The solar power
cable will fit behind the console.)
10. Plug the console power cable into the console. Follow the console setup
procedures in your Vantage Pro2 Console Manual.
11. Close and lock the shelter.
E
E
VV VV
VP2 VP2
ENVOY Vantage VUE Vantage PRO2