beautypg.com

Mounting on a post or flat surface – DAVIS Solar Power Kits (6612, 6614) User Manual

Page 20

background image

19

Mounting on a Post or Flat Surface

Attach the shelter to the mounting surface in the desired location using the large
screws,1/4'' flat washers, and backing plates as shown below. Use a pencil or a
center-punch to mark the location of the pilot hole.

1. With a 3/16'' (5 mm) drill bit, drill two holes approximately 2'' (50 mm) apart.

Use a carpenter’s level to ensure the holes will be level.

2. Drill two more holes 7-1/32'' below the upper holes.
3. Insert the 1/4'' x 1-1/2'' lag screws through the backing plate and the holes at

the top of the shelter into the post.

4. Using an adjustable wrench or 7/16'' wrench, tighten the lag screws.
5. Repeat steps 3 and 4 for the bottom of shelter.