DAVIS Cellular Telephone Antenna Kit - Manual (Page 7)

Typical Installations Page 7
Solar-Powered Using Alarm Output Module
The illustration below shows a solar-powered station and CTM using the
Alarm Output Module (AOM) for power conservation.
You must complete the following steps for this installation.
1. Configure the CTM (see “Configuring The Cellular Telephone Modem” on page 8).
2. Install antenna (see “Installing Antenna” on page 11).
3. Install Solar Power Kit and 6.5-Amp-Hour Battery (see “Installing Solar Power Kit &
Battery” on page 12).
4. Install Alarm Output Module.
Consult the manual supplied with the AOM for instructions. Make sure to
mount the AOM in the location shown above.
5. Install Radio Surge Protector (optional).
Consult the manual supplied with the Radio Protector for installation
instructions.
6. Install CTM (see “Installing Cellular Telephone Modem” on page 13).
7. Install terminal plate (see “Installing Terminal Plate/Timer” on page 15).
8. Connect Alarm Output Module and battery wires (see “Connecting Alarm Output Mod-
ule and Battery Wires” on page 19).
Sensor
Interface
Module
Cell Phone
Handset
Regulator
In-Line
Fuses
Battery
Console
Terminal
Block
CTM Power
Cable
Radio Surge Protector (optional)
To Antenna
Protector Ground
CTM
Link Adapter
Alarm Output
Module (AOM)