DAVIS Cellular Telephone Antenna Kit - Manual (Page 4)

Page 4 Cellular Telephone Antenna Kit
T OOLS R EQUIRED
In addition to the components listed above, you may need the following tools.
Please be sure you have everything you need before beginning the installation.
✦ Phillips Screw Driver
✦ Slotted Screw Driver
✦ Electric Drill with 7/32" (5.5 mm) and 1/8" (3 mm) drill bits
T YPICAL I NSTALLATIONS
The illustrations below show three typical installations: AC-powered, solar-
powered using the Timer, and solar-powered using the Alarm Output Module.
A list of steps for each installation type is provided.
AC-Powered
The illustration below shows an AC-powered station and cellular telephone
modem (CTM).
You must complete the following steps for this installation.
1. Configure the CTM (see “Configuring The Cellular Telephone Modem” on page 8).
2. Install antenna (see “Installing Antenna” on page 11).
3. Install Radio Surge Protector (optional).
Consult the manual supplied with the Radio Protector for installation
instructions.
Cell Phone
Handset
Console
Sensor
Interface
Module
Terminal
Block
CTM Power
Cable
Radio Surge Protector (optional)
To Antenna
Protector Ground
CTM
Link Adapter
+12 V AC-Power
Adapter