DAVIS Cellular Telephone Antenna Kit - Manual (Page 6)

Page 6 Cellular Telephone Antenna Kit
1. Configure the CTM (see “Configuring The Cellular Telephone Modem” on page 8).
2. Install antenna (see “Installing Antenna” on page 11).
3. Install Solar Power Kit and 6.5-Amp-Hour Battery (see “Installing Solar Power Kit &
Battery” on page 12).
4. Install Radio Surge Protector (optional).
Consult the manual supplied with the Radio Protector for installation
instructions.
5. Install CTM (see “Installing Cellular Telephone Modem” on page 13).
6. Install terminal plate and Timer (see “Installing Terminal Plate/Timer” on page 15).
7. Connect Timer and battery wires (see “Connecting Timer and Battery Wires” on
page 17).
8. Install hand set and hang-up cups (optional; see “Installing Handset and Hang-Up
Cups” on page 20).
If you wish to originate or receive voice calls at the weather station/CTM
site, you will need to install the handset and hang-up cup assembly.
9. Check wiring.
Before you apply power to the system, review your wiring to make sure all
connections are correct and all wires firmly secured in the proper terminal.
10. Connect power to system.
Do not connect power until the rest of your installation is complete. Connect the
battery cable to B2 on the regulator circuit. Connect the solar panel cable to
B1 on the regulator circuit. Finally, insert the fuse into the in-line fuse holder
in the red battery wire.
11. Finalize the installation by programming the Timer and testing the system (see “Final-
izing the Installation” on page 21).