DAVIS Cellular Telephone Antenna Kit - Manual (Page 12)

Page 12 Cellular Telephone Antenna Kit
✦ Installing on Pipe, Post, or Wall
Mount the Antenna Mounting Bracket (AMB) on the pipe, post, or wall
according to the instructions supplied with the bracket. Attach the
antenna to the ground plane as shown below; screw on until snug.
Attach the ground plane to the AMB using the #8-32 x
¾
" screws, flat
washers, split lock washers, and hex nuts as shown below.
Installing Solar Power Kit & Battery
Consult the manuals supplied with the appropriate component for instruc-
tions. Note the following, however, as you proceed with the installation.
✦ Use tab adapters to attach wires to the battery.
Before installing the battery, slide the tab adapters onto the terminals.
Attach the black battery wire (supplied with this kit) and the black wire
from the battery cable (supplied with the Solar Power Kit) to the tab
adapter connected to the ground (black) terminal. Attach the red battery
wire (suppplied with this kit) and the red wire from the battery cable
(supplied with the Solar Power Kit) to the tab adapter connected to the
positive (red) terminal. Make sure you have access to the free end of the
battery wires and the battery cable once the battery is installed.
✦ Do not connect the solar panel or the battery to the regulator circuit.
Make sure you have made no connections at B1 and B2 on the regulator
circuit before proceeding.
Antenna
Ground
Plane
8-32 ¥ 3/4" Screw
Flat Washer
Flat Washer
Split LockWasher
#8 Hex Nut
Antenna Mounting
Bracket Lag Screws
(to mount on pipe,
use 11/2" U-bolts and
1/4" nuts & washers)