beautypg.com

AMT Datasouth 600 User Manual

Page 25

background image

User Manual

23

5. Position the Media Backing out of the printer and over the Peel Bar.

6. Push the Media Backing in the slot just under the Peel Bar and between the front cover.

Continue to push the stock until it comes out of the larger slot in the front cover.

7. If the Media Backing will not push through, then press the Feed button one time.

8. Once the media comes out of the larger slot, gently roll the excess media back onto the

Media Roll until the Backing is snug around the Peel Bar.

Figure 23 – Feeding into the Peeler Mechanism

9. In this position the Media Backing coming out of the large slot in the front cover should

be aligned with the Labels coming out of the printer.

Figure 24 – Backing Exit Position

Note:

If not, then pull down the Peeler Latch and gently pull the backing until they are aligned.
Make sure to close the Peeler Latch when done.

Label

Platen Roller

Backing

Peeler Roller

Media Stock from Media Roll

Peeler Bar

This manual is related to the following products: