AMT Datasouth 600 - Manual (Page 18)

16 User Manual
8. Loop the ribbon over the Print Head Module. Insert the Take-up Core into the Take-Up
Area by first compressing the right side spring and snapping the left side of take-up core
into the left side of the notched wheel. Make sure that the slots in left side of the core
mate with the notches on the left side ribbon drive wheel.
Figure 11 – Ribbon Take-Up Installation
9. To remove any slack in the ribbon, manually rotate the Take-up Core Wheel until the
ribbon from the Supply Holder is snug around the Print head Module and onto the Take-
up Core.
Figure 12 – Ribbon Installation
Ink Side of the Ribbon
Print Head Module
Take-Up Core