JKS OGS166 - Manual (Page 5)

JKSOGS166 JKS Front Trackbar + Sector Shaft Reinforcement Installation Page 5
 Make sure Steering Sector Pillow Block is square
to Trackbar Chassis Bracket (A). HINT: Pillow
block does not need to be perfectly level front-to-
back because Spherical Bearing (F) will compen-
sate for misalignment.
 If necessary, adjust front-to-back angle of Steer-
ing Sector Pillow Block until square with Trackbar
Chassis Bracket. HINT: A pry bar may be useful
for applying leverage to pillow block while fine tun-
ing the side-to-side or front-to-back alignment.
 Once Steering Sector Pillow Block (E) is properly
positioned, add tension to both 3/8” x 1” Bolts (L)
and 1/2” x 2” Bolt (U) until snug to prevent Pillow
Block from accidentally moving.
‰ 3. INSTALL PILLOW BLOCK FRAME
MOUNT ON CHASSIS
 With mounting bolts snug, turn your attention to
the Pillow Block Frame Mount (I). Make sure weld-
on mount is square to Pillow Block while posi-
tioned as close to chassis as possible.
HINT: A small gap between the weld-on mount
and chassis is normal and acceptable.
 Use a marker or scribe to outline the location of
Pillow Block Frame Mount (I) onto chassis. Make
sure both sides and bottom of mount are clearly
transferred to chassis as this indicates where paint
needs to be removed prior to welding.
 Remove the two 3/8” Bolts and 1/2” Bolt holding
the Pillow Block to Trackbar Chassis Bracket, and
slide the Pillow Block off of the Sector Bearing
Nut.