JKS OGS166 - Manual (Page 4)

JKSOGS166 JKS Front Trackbar + Sector Shaft Reinforcement Installation 4 Page
Product:
Sector Shaft Brace
Installation
‰ 2. PRE-FIT STEERING SECTOR PILLOW
BLOCK
 Remove original pitman arm nut.
 Install Sector Bearing Nut (G) with 7/8” Split
Washer (H) onto sector shaft. Tighten nut to 185
ft-lbs. using a torque wrench.

 Loosely install Pillow Block Frame Mount (I) on
Steering Sector Pillow Block (E) with the 7/16” x
1-3/4” Bolt (J) and 7/16” Split Washer (K) exactly
as illustrated below.
 Place a 3/8” Split Washer (N) and 3/8” Flat Washer
(M) onto supplied 3/8” x 1” Bolts (L).
 Slide Pillow Block assembly onto Sector Bear-
ing Nut (G) and insert both 3/8” Bolts through the
Trackbar Chassis Bracket (A) and into threaded
holes in Pillow Block to hold the assembly in posi-
tion. Finger tighten bolts.
 For alignment purposes, also insert one of the
1/2” x 2” Bolts (U) – supplied with Chassis Brace
Connector PN OGS164 – through Trackbar Chas-
sis Bracket (A) and into the corresponding hole in
Pillow Block (E). Finger tighten 1/2” Bolt.
 Raise the Steering Sector Pillow Block (E) as high
on Sector Bearing Nut (G) as possible. HINT:
Holes in Trackbar Chassis Bracket are elongated
to compensate for factory variances on elevation
of steering box.
 Make sure Steering Sector Pillow Block (E) is level
side-to-side.