JKS 6100 User Manual
Installation instructions, Welcome, Tools required
![background image](/manuals/402742/1/background.png)
JKS6100
JKS Adjustable Control Arm Installation
Page 1
INSTALLATION
INSTRUCTIONS
Product: Adjustable Lower Control Arms
Part Number: JKS6100
Welcome
CONGRATULATIONS on purchasing a set of new
Adjustable Control Arms from JKS Manufacturing. We
are committed to providing you with the best products
available and your satisfaction is our first priority.
PLEASE READ these Installation Instructions careful-
ly, and save them for future reference, as they contain
important installation and maintenance information.
Tools Required
Metric/Standard Socket Wrench Set
Torque Wrench
Tape Measure
Anti-Seize Lubricant
Hydraulic Floor Jack & Jack Stands
Heavy Duty Ratchet Strap *
Factory Service Manual (recommended)
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions first to determine which tools
will be required for your application.
Important
SUSPENSION COMPONENTS THAT HAVE RUB-
BER BUSHINGS must be tightened with vehicle
on level ground and at normal ride height. The
springs must be supporting the weight of the
vehicle when the hardware is torqued; or else ride
comfort could be affected and premature bushing
wear may occur.
RUBBER BUSHINGS MUST NEVER BE LUBRI-
CATED, as doing so will impair performance and
longevity.
COMPATIBLE WITH original 4-link suspension
configuration and vehicle ride height up to 6.0”.
REFER TO FACTORY SERVICE MANUAL for
information and procedures not covered in these
instructions.
ATTENTION INSTALLER
Install Adjustable Control Arms ONE AT A TIME
for easiest alignment of mounting hardware.
Installation
1. REMOVE ORIGINAL LOWER
SUSPENSION ARM
Raise and support the vehicle chassis with jack
stands.
Â
FRONT INSTALLATION – Position behind
front lower suspension arm brackets.
Â
REAR INSTALLATION – Position in front of
rear lower suspension arm brackets.
517-278-1226 • [email protected] • www.jksmfg.com
491 W. Garfield Avenue, Coldwater, MI 49036
Applications: Wrangler TJ, 1997-06 (front or rear)
Gr. Cherokee ZJ, 1993-98 (front or rear)
Grand Cherokee WJ, 1999-04 (front only)
Cherokee XJ, 1984-01 (front only)
Comanche MJ, 1986-92 (front only)