JKS 9902 - Manual

JKS9902 JKS Body Lift Installation Page 1
INSTALLATION
INSTRUCTIONS
Product: B1 Body Lift
Part Number: JKS9902
Applications: CJ5 & CJ7, 1976-86
Welcome
Congratulations on purchasing a new B1 Body Lift from
JKS® Manufacturing. We are committed to providing you
with the best products available and your satisfaction is our
first priority.
We hope you enjoy your JKS® purchase and are here to
help if you still have questions after reviewing this safety
information and instructions. Contact us online at www.
jksmfg.com or by phone at 877-533-7557.
Important
NOT COMPATIBLE WITH aftermarket swaybars. Install
product with Original Equipment swaybar only.
SOME VEHICLES MAY REQUIRE extended front brake
hoses or other modifications to compensate for ad-
ditional suspension travel.
NEVER DISCONNECT swaybar when operating vehicle
on public roads.
WHEN DISCONNECTED, swaybar must be secured to
prevent interference with other suspension compo-
nents or axle.
Tools Required
 Metric/Standard Socket Wrench Set
 Torque Wrench
 Tape Measure
 Medium Strength Threadlocker
 Hydraulic Floor Jack
 Sturdy Block of Wood (to protect body)
 Center Punch and Hammer
 3/8” Drill Bit
 1/8” Drill Bit or Torch * (for removing plastic rivets
in steering slip shaft)
 Reciprocating Saw or Die Grinder with Cut-Off Wheel *
(for trimming fan shroud)
 Wire Brush *
 Factory Service Manual (recommended)
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions first to determine which tools
will be required for your application.
CAUTION
Always Wear Protective Gear
Safety glasses and protective gloves are required.
Parts
Description QTY
A Dura-Thane™ Body Puck 11
B 3/8” x 3-1/2” Bolt 6
C 3/8” x 4” Bolt 2
D 3/8” Flat Washer 8
E 7/16” x 4” Bolt 3
F 7/16” Flat Washer 3
517-278-1226 • [email protected] • www.jksmfg.com
491 W. Garfield Avenue, Coldwater, MI 49036