JKS OGS169 User Manual
Installation instructions, Welcome, Tools required

JKSOGS169
JKS Rear Trackbrace Installation
Page 1
INSTALLATION
INSTRUCTIONS
Product: Rear Trackbar Brace
Part Number: JKSOGS169
Applications: Jeep Wrangler JK, 2007+ (rear)
Welcome
CONGRATULATIONS on purchasing a new Rear Trackbar
Brace from JKS Manufacturing. We are committed to
providing you with the best products available and your
satisfaction is our first priority.
PLEASE READ these Installation Instructions carefully,
and save them for future reference, as they contain impor-
tant installation and maintenance information.
Tools Required
Metric/Standard Socket Wrench Set
Torque Wrench
Die Grinder with Sanding Wheel
(or equivalent tool for removing paint)
Welding Equipment
Weldable Corrosion Resistant Coating,
3M® PN 05917 (or equivalent)
Satin Black Spray Paint
Anti-Seize Lubricant
Factory Service Manual (recommended)
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions first to determine which tools
will be required for your application.
Important
INSTALLATION REQUIRES WELDING by a qualified
welder or metal fabricator.
Installation
1. REMOVE REAR TRACK BAR
Remove rear track bar mounting hardware from
axle and chassis brackets per factory service
manual instructions for your vehicle. Retain origi-
nal hardware.
Remove rear track bar from vehicle.
Prime entire surface of Trackbar Brace with 3M®
Weldable Corrosion Resistant Coating (or equiva-
lent – must be weldable).
2. PREPARE AXLE FOR WELDING
To ensure a proper fit, clean any dirt, debris or
grease from surface of factory track bar bracket.
517-278-1226 • [email protected] • www.jksmfg.com
491 W. Garfield Avenue, Coldwater, MI 49036