HP PSC 2210xi All-in-One Printer - Manual (Page 61)

restore factory defaults 55
hp psc 2200 series
restore factory defaults
You can restore the original factory settings to what they were when you
purchased your HP PSC. Choosing to restore your factory defaults restores
all settings, except date information.
You can perform this process from the front panel only.
1 Press Setup.
2 Press 5, then press 3.
This selects Maintenance, and then selects Restore Factory Defaults.
The factory default settings are restored.
set the power save time
The bulb in your HP PSC remains on for a specified period so that the unit
is immediately ready to respond to your request. When the HP PSC has not
been used within that specified period, it turns the bulb off to preserve
power and displays Power Save On in the front-panel display. (You can exit
this mode by pressing any button on the front panel.)
Your unit is automatically set to enter power-save mode after 12 hours.
Follow these steps if you want the HP PSC to enter this mode earlier.
1 Press Setup.
2 Press 5, then press 6.
This selects Maintenance, and then selects Power Save Mode Time.
3 Press until the desired time appears, then press Enter.
set scroll speed
The Scroll Speed option lets you control the rate that text messages appear
in the front-panel display. You can choose Normal, Fast, or Slow. The
default is Normal.
1 Press Setup.
2 Press 5, then press 7.
This selects Maintenance, and then selects Set Scroll Speed.
3 Press until the desired speed appears, then press Enter.
set the prompt delay time
The Prompt Delay option lets you control the amount of time before a
message is displayed in the front-panel display. You can choose Normal,
Fast, or Slow. The default is Normal.
1 Press Setup.
2 Press 5, then press 9.