HP PSC 2210xi All-in-One Printer - Manual (Page 48)

use the fax features 42
hp psc 2200 series
1 Press Fax, if not already lit.
2 Press Options.
–
Press Enter to select Fax Mode, then enter the fax number.
– Or, press until Speed Dials appears, press Enter, then select a
speed dial.
3 Press Options until Lighter/Darker appears.
The range of values appears as a circle on a scale on the display.
4 Press to lighten the fax or to darken it.
The circle moves to the left or right, depending on the button you
press.
5 Press Enter to use the selected setting.
redial a busy or unanswered number automatically
You can set your HP PSC to redial a busy or an unanswered number
automatically. The default setting for Busy Redial is Redial. The default
setting for No Answer Redial is No Redial.
1 Press Setup.
2 Do one of the following:
–
Press 4, then press 3.
This selects Advanced Fax Setup, then selects Busy Redial.
– Press 4, then press 4 again.
This selects Advanced Fax Setup, then selects No Answer Redial.
3 Press to select Redial or No Redial, as desired.
4 Press Enter.
use error correction mode (ECM)
ECM eliminates data lost due to poor phone lines by detecting errors that
occur during transmission and automatically requesting retransmission of
the erroneous portion. Phone charges are unaffected, or may even be
reduced, on good phone lines. On poor phone lines, ECM increases
sending time and phone charges, but sends the data much more reliably.
Turn ECM off (the default setting is on) only if it increases phone charges
substantially and you are willing to accept poorer quality in exchange for
reduced charges.
1 Press Setup.
2 Press 4, then press 7.
This selects Advanced Fax Setup, then selects Error Correction Mode.
3 Press to switch between Off and On.
4 Press Enter to use the selected setting.