HP XP P9500 Storage - Manual (Page 57)

To resynchronize the pairs in a mirror, specify a Cnt Ac-J Z pair in the mirror. Specify Mirror for
the Range parameter. This splits all pairs.
Range/Character
Numbers Content Parameter Column
00 LDKC number of the primary data volume LDKC A
00 to FE CU number of the primary data volume CU B
00 to FF LDEV number of the primary data volume LDEV C
00 to 03 Mirror ID Mirror ID D
00 to 1FF Master journal ID M-JNL E
00 to FF DKC number of the remote storage system LDKC(Pair) F
00000 to 99999 Serial number of the secondary storage system DKCSN G
N/A Normal: The pair in Suspend status is resynchronized. ResyncMode
1
H
N/A Mirror: All pairs in the same mirror are resynchronized. Range
2
I
Volume: Only specified pair in the mirror is resynchronized.
1 to 256
3
Priority of the operation Priority J
N/A Mirror: When a failure occurs, all the pairs in the same mirror are
split. ErrorLevel
4
K
Volume: When a failure occurs, only the specified pair is split.
N/A Specify the current setting (Only_P-VOL or Copy_to_S-VOL). CFW L
Notes:
1. Use Business Continuity Manager to resynchronize the pair for delta resync operation.
2. If Mirror is specified for Range, the setting of Priority, ErrorLevel, and CFW are ignored. When the pair is in “Pending”,
“Duplex”, or “Suspend” status and Mirror is specified for Range, all pairs in the same mirror are resynchronized. If a Suspend
pair does not exist in the mirror, an error occurs. An error also occurs if you specify multiple Continuous Access Journal pairs
in the same spreadsheet. The XP24000/XP20000 Disk Array Group option is also available for this field. The setting is the
same whether you specify Mirror or Group; however, Mirror is recommended.
3. Though the smaller the number the higher the priority, when adding many pairs at a time, specifying the Priority parameter
may not be enough to manage the priority of adding pairs operation. Therefore, to insure the pairs are added by priority, it
is recommended that you separate the spreadsheets for high priority pairs and other pairs.
4. The XP24000/XP20000 Disk Array Group option is also available for this field. The setting is the same whether you specify
Mirror or Group; however, Mirror is recommended.
Releasing Continuous Access Journal Z pairs
Use the RemoteCopyJournalMF_DeletePair_def_.spd spreadsheet template to release a
Cnt Ac-J Z pair. You can use the output from the GetPair operation in this spreadsheet. Release
pairs on the primary or secondary system.
Range Content Parameter Column
00 LDKC number of the primary data volume LDKC A
00 to FE CU number of the primary data volume CU B
00 to FF LDEV number of the primary data volume LDEV C
00 to 03 Mirror ID Mirror ID D
N/A P-VOL VolType
1
E
S-VOL
00 to FF DKC number of the remote storage system LDKC(Pair) F
Running CLI-based spreadsheets in Continuous Access Journal Z 57