HP XP P9500 Storage - Manual (Page 43)

The parameters are described in the following table.
Characters Values Description Parameter Column
First Layer: Information about external volumes and the primary path.
5 decimal digits or
less 0 to 63231 Path group number. PathGroup A
2 digits or less 1A to GR Port number of the primary path. Port B
16 hexadecimal
digits 0000000000000000
toFFFFFFFFFFFFFFFF WWN of the primary path. WWN C
4 hexadecimal
digits or less 0000 to 0FFF LU number set to the external volume. LUN D
Grp: 5 decimal
digits or less Grp: 1 to
16384 External volume group number and its sequential number.
The format should be EGrp-VPG (for example,
E16384-4096). ExG E
VPG:4 decimal
digits or less VPG: 1 to 4096
N/A Normal Attribute F •
Normal: Maps an external volume.
R-CMD •
R-CMD: Maps a command device.
2 decimal digits or
less 0 to 31 CLPR that is used to access the external volume. CLPR G
Second Layer: Information about alternate paths. Specify the paths in the order of descending priorities.
N/A N/A Identifier + A
2 digits or less 1A to GR Port number of the alternate path. Port B
16 hexadecimal
digits 0000000000000000
to
FFFFFFFFFFFFFFFF WWN of the alternate path. WWN C
Third Layer: Information about the LDEV to be created in the external volume.
N/A N/A Identifier + A
+ B
2 hexadecimal
digits or less 00 to 01 LDKC number LDKC C
2 hexadecimal
digits or less 00 to FE CU number CU D
2 hexadecimal
digits or less 00 to FF LDEV number. Specify a number not currently assigned.
Note, though, that LDEV numbers may be assigned in LDEV E
another emulation group (grouped by 32 LDEV numbers),
in which case you cannot user them.
For more information, see the HP P9000 Provisioning for
Open Systems User Guide or the HP P9000 Provisioning
for Mainframe Systems User Guide.
Check to see if a number is assigned. To do this, open
RWC and check the LDEV tab on the Basic Information
Display dialog box (File > Go > Basic Information).
4 hexadecimal
digits or less 0004 to FFFE SSID assigned to the range of the LDEV numbers. Use the
SSID shown in the output file from the SSID F
ExternalStorage_Get_def.spd spreadsheet for the
range. If you create an LDEV that does not have any SSID,
specify an SSID that is not written in the output file.
Running CLI-based spreadsheets 43