HP Integrity Superdome 2 Server - Manual (Page 51)

10 Enclosure Bay IP Addressing commands
ADD EBIPA
•
Command:
ADD EBIPA { BLADE | INTERCONNECT } DNS <ip address> [ { , | - } <bay
number> ]
NOTE: SERVER is a valid alias for BLADE.
•
Description:
Adds a DNS server IP address to the list of DNS servers for either BLADE bays or
INTERCONNECT
bays
•
Access Level/Bay level:
Administrator, Operator
•
Restrictions:
A maximum of three DNS servers can be added for EBIPA. ◦
◦ The <ip address> must be in the form ###.###.###.###, where each ### ranges
from 0 to 255.
DISABLE EBIPA
CAUTION: This command cycles power to the interconnect and causes a loss of connectivity.
•
Command:
DISABLE EBIPA {BLADE|INTERCONNECT} [ALL | <bay number> [{ , | - }
<bay number>]]
•
Description:
Disables the ability of the Onboard Administrator to give devices in the bays IP addresses
using DHCP.
If no bay numbers are specified, then EBIPA is disabled for all bays. Devices in bays receive
IP addresses from an external server.
This causes a reset of the iLO, which causes it to attempt to get an IP address from an external
DHCP server. The interconnect is power-cycled.
•
Access level/Bay level:
Administrator, Operator
•
Restrictions:
None
ENABLE EBIPA
CAUTION: This command cycles power to the interconnect and causes a loss of connectivity.
•
Command:
ENABLE EBIPA {BLADE|INTERCONNECT} [ALL | <bay number> [{ , | - }
<bay number>]]
ADD EBIPA 51