HP Virtual Connect Enterprise Manager Software - Manual (Page 79)

Description Setting
IP network mask used by the iSCSI initiator. This value
is in dotted-decimal format. Netmask (required)
Default IP route used by the iSCSI initiator. This value is
in dotted-decimal format. Gateway (optional)
8. (Optional) Select Use Boot Assistant... and the iSCSI Boot Assistant window opens. Figure 30
displays the iSCSI Boot Assistant window.
NOTE: The Use Boot Assistant option is only available for HP 4000 SAN solutions.
Figure 30 iSCSI Boot Assistant
HP recommends that you use the iSCSI Boot Assistant rather than populating the iSCSI fields
manually. The main goal of the iSCSI Boot Assistant is to save time. If you run the iSCSI Boot
Assistant after manually populating the iSCSI fields, the values previously entered manually
will be overwritten.
1. Choose a VC Domain and the Management Targets: selection box is enabled. The list of
available management targets is dependent on the storage management credentials
configured in each VC Domain. Each VC Domain can have a list of different iSCSI targets
in its storage management credential configuration area.
2. Choose a management target, and the Boot Volume: selection box is enabled. Select a
boot volume and then click OK.
9. In the Fibre Channel SAN connections table, set the Fibre Channel SAN connections. To add
more connections in a VC Domain, click Add FC SAN Connection. You can add up to 8
connections per slice, for a maximum of 4 slices and 32 connections. If you enter the maximum
connections allowed, Add is disabled and an error message is displayed. To remove a
connection, click the X icon at the right side of the table.
Creating a server profile 79