Figure 38 select an ldev number, 38 select an ldev number – HP StorageWorks XP Remote Web Console Software User Manual
Page 73
LUN Configuration and Security Manager XP user guide for the XP1024/XP128
73
NOTE:
The CU number of another SLPR is used check box is displayed only when you logged in
as a user in the StorageAdmin group with full array access and when there are two or more SLPRs.
When the CU number of another SLPR is used check box is selected, you can select the number of
an LDEV that does not exist in an SLPR to which the priority group does not belong. When the
check box is cleared, you can only select the number of an LDEV in the SLPR to which the parity
group belongs.
Figure 38
Select an LDEV number
The CU:LDEV number in the CV setting information area is updated.
NOTE:
If you specify an LDEV number in the selected CU, free sequential LDEV numbers in LUSE
configuration are automatically assigned. You cannot specify an LDEV number, if free LDEV
numbers in LUSE configuration are not available in either of the following CUs:
• The CU displayed in the Select CU No. list.
• A CU whose CU number is larger than the CU number displayed in the Select CU No. list.
10.
to set additional custom volumes.
11.
To change a set volume, right-click the volume in the CV setting information area, and select Clear.
12.
After setting all CU and LDEV numbers, click Next.
If the boundary area of the selected LDEV number does not have an SSID, a dialog box is displayed
for setting the SSID (
). Go to
.