HP Designjet 9000s Printer series - Manual (Page 73)

5. Open the cap cover and loosen the head fixing screws (2) with a screwdriver.
1. Capping unit cover
2. Head fixing screws
6. Change the height of the head by lifting the head height lever to lower the head, or by lowering the
head height lever to lift the head.
1. Printhead height lever
7. Tighten the head fixing screws (2) using the long screwdriver provided with your printer.
NOTE Tighten the head fixing screws while applying slight downward pressure on the
head using your hand.
8. Close the rear cover.
ENWW Change the printhead height 63
How
do
I… (
ink t
opics)