HP Designjet 9000s Printer series - Manual (Page 39)

11. Feed the media until a beep sounds from the media feeder (about 200 mm).
NOTE If you have problems loading media, feed the media into the printer by holding
both edges of the media.
Take care that the media does not curl inside the rear cover and that the media edge
guards are not obstructing the media path. See How do I... Use the media edge guard.
NOTE The vertical media line guide on the printer is for sheet media loading only. Do
not use for roll media.
12. Take up any excess media by rewinding the media stop on the media roll. This will help to make
sure there is even tension across the width of the media and avoid skew.
1. Rewind excess media onto the roll.
ENWW Install a media roll in the printer 29
How do
I load/unload
media?