HP Designjet 9000s Printer series - Manual (Page 171)

Parameters: none.
NOTE Always perform Cleaning (normal) after filling the cap.
If the printhead surface is not clean even after leaving the printer overnight, then contact HP
Support.
Printhead height (PH HEIGHT ADJ)
Use this menu option to adjust the printhead height.
The cap is opened after performing this operation and the carriage height can be adjusted. See How do
I... Change the printhead height.
Parameters: none.
The PH.RECOVERY menu
This menu is used to clean the printheads of the printer. See How do I... Normal printhead recovery.
Press the ◄ key to select the PH.RECOVERY menu options.
◄ key
Parameters:
● NORMAL ALL — Performs normal cleaning of all the printheads.
● STRONG ALL — Performs strong cleaning of all the printheads.
● STRONG Lc,Lm,K — Performs strong cleaning of light cyan, light magenta and the black
printheads.
● STRONG Y,M,C — Performs strong cleaning of cyan, magenta and the yellow printheads.
The FEED menu
This option allows you to feed media through the printing path. Press and hold down the ▼ key to feed
the media through the printing path. If a cut sheet is used, it is discharged.
ENWW The PH.RECOVERY menu 161
Tell me about
f
ront
panel menus