HP Designjet 9000s Printer series - Manual (Page 63)

4. Lower the media load lever.
5. Select NEST in the SELECT MEDIA menu and press the OK key.
NOTE In the next steps, use the MEDIA WIDTH setting if you cut the media to remove
the image that was previously printed. Use the NEST ORIGIN setting if you have not cut
the media and to start printing from a point that excludes the previously printed image.
6. Enter the media width and press the OK key. The media width previously detected is displayed.
(Media width input range: 290 to 1635 mm)
ENWW Use manual nesting 53
How
do I...
(printing topics)