HP Designjet 9000s Printer series - Manual (Page 25)

2 How do I perform basic operations?
● Connect to a computer
● Turn the power on/off
Connect to a computer
This section describes system configuration and cable connection procedures.
NOTE Before connecting or disconnecting the USB cable, turn the printer OFF.
Choose the system configuration
The following connections are possible.
1. Printer
2. USB interface
3. Printer server (RIP)
Connection procedure
NOTE Before you connect the USB cable, you should ensure that the RIP is installed so that
the printer can be detected by your operating system. Refer to the instructions that came with
your RIP for installation instructions.
Connect a USB cable as follows:
1. Disconnect the USB cable from the rear of your printer if it is already connected.
2. Turn the printer off at the front panel.
3. Power off the printer using the power switch at the rear.
4. Connect a USB cable to the USB connector at the rear of the printer.
5. Connect a USB cable to the USB connector at the rear of the computer.
6. Power on the printer using the power switch at the rear.
7. Turn the printer on at the front panel.
8. On your computer, select the printer.
ENWW Connect to a computer 15
How
do I
perf
orm
basic
operat
ions?