HP Designjet 9000s Printer series - Manual (Page 183)

Status: Status of maintaining each heater temperature at the preset temperature on the heater front
panel.
Conditions: 1. If the heater ON/OFF setting on the heater front panel is set to ON and a print command
is received.
2. Under condition (1) above, and the time specified by the delay time after the print end
command was received.
Maintaining the standby temperature
Function: To shorten the time needed to reach the preset temperature to start printing.
Status: Status of maintaining the heater temperature at the specified standby temperature (35 °C) for
all heaters.
When the preset temperature is lower than the specified standby temperature (35 °C), the
printer maintains the preset temperature.
Conditions: If the standby time has been set, after reaching the preset temperature.
Turning off the heaters
Function: To prevent excessive current consumption, to protect the media from damage by the heat
from the heaters, and to protect the user from getting burned from touching the heaters when
printing is not performed.
Status: Status of reaching the environmental temperature slowly.
Conditions: In all cases except when maintaining the preset temperature or the standby temperature.
Start of heating: The print start command is received and heating starts. Printing does not start until the heaters
have reached the preset temperature.
Start of print: The heaters reach the preset temperature and printing starts.
End of print: The print end command is received and printing finishes.
The heater front panel
Display in normal mode
ENWW Heater temperature settings 173
Tell me about
t
h
e heat
ers