HP Designjet 9000s Printer series - Manual (Page 170)

Parameters:
● STORE INK SYS — Use this parameter to clean the printheads and ink path with the storage liquid
while the ink system is primed with ink, and then recharge the maintenance liquid in the printer to
ensure long-term storage. Six storage liquid cartridges and six cartridges are mandatory.
● CLEAN INK SYS — Use this parameter to clean the printhead with the cleaning liquid after long-
term storage. Six cleaning liquid cartridges and six purging cartridges are mandatory.
● CAP CLEANING — Use this option to move the printhead carriage to the wiper position so that
you can clean the capping unit manually.
● WIPER CLEANING — Use this option to lift the wiper blade so that you can clean the wiper blade
manually.
● WASH PRINTHEADS — Use this option to fill the cap with ink to soak the printhead (nozzle
surface) in the ink for 1 to 2 hours to remove nozzle clogging.
● CHARGE INK SYS — Use this parameter when charging the ink system.
Cap cleaning (CAP CLEANING)
Use this option to move the printhead carriage to the wiper position so that you can clean the capping
unit manually.
Parameters: none.
Wiper cleaning (WIPER CLEANING)
Use this option to lift the wiper blade so that you can clean the wiper blade manually.
Parameters: none.
Washing printheads (WASH PRINTHEADS)
Use this option to fill the cap with ink to soak the printhead (nozzle surface) in the ink for a minimum of 1
to 2 hours to remove nozzle clogging. If possible, leave the printer overnight.
Use this option when nozzles cannot be fixed by cleaning repeatedly.
160 Chapter 14 Tell me about front panel menus ENWW
Tell me about
f
ront
panel menus