HP ProLiant DL380 G5 Server User Manual
Page 50
•
Serial Number—Displays the unit serial number for the tape library. Use this value for identification purposes.
•
Protocol Type—Displays the protocol used to communicate with the tape library. The following values are valid:
•
Parallel SCSI—The protocol is Parallel SCSI.
•
Serial ATA—The protocol is Serial ATA.
•
SAS—The protocol is Serial Attached SCSI.
•
Unknown—The Storage Agents are unable to determine the protocol.
•
Current Width—Displays the current negotiated data transfer width for Parallel SCSI tape libraries. The possible
values are:
•
Narrow (8 bits)—The negotiated data transfer width for this tape library is narrow (8 data bits).
•
Wide (16 bits)—The negotiated data transfer width for this tape library is wide (16 data bits).
•
Unknown—The Storage Agents are unable to determine the current negotiated data transfer width for this
tape library.
•
Current Speed—Displays the current negotiated data transfer speed for Parallel SCSI tape libraries. The
possible values are:
•
Asynchronous—The current data transfer speed for this tape library is asynchronous.
•
Fast—The current data transfer speed for this tape library is 10 million transfers per second.
•
Ultra—The current data transfer speed for this tape library is 20 million transfers per second.
•
Ultra2—The current data transfer speed for this tape library is 40 million transfers per second.
•
Ultra3—The current data transfer speed for this tape library is 80 million transfers per second.
•
Unknown—The agent is unable to determine the current negotiated data transfer speed for this tape library.
NOTE:
If the current data transfer width is Narrow (8 bits) then the speed in megabytes per second is
equal to the million transfers per second speed. If the current width is Wide (16 bits) then the speed
in megabytes per second is twice the million transfers per second speed. For example, if the current
speed is Ultra and the width is Wide then the speed would be 40 megabytes per second.
•
Negotiated Link Rate—Displays the negotiated link rate for SAS and SATA tape libraries. The possible values
are:
•
1.5 Gbps—The negotiated link rate for this tape library is 1.5 gigabits per second.
•
3.0 Gbps—The negotiated link rate for this tape library is 3.0 gigabits per second.
•
Unknown—The agent is unable to determine the negotiated link rate for this tape library.
•
Door Status—Displays the status of the door. The following values are valid:
•
Not Supported—The door status is not supported by the device.
•
Closed—The door is closed.
•
Open—The door is open.
•
Unknown—The state of the tape library door cannot be determined. You may need to upgrade the Storage
Agents.
•
Total Moves—Displays the number of tape moves for the library loader arm.
•
Service Hours—Displays the number of hours of operation for the library.
Associated Tape Drives
To see more information about the tape drive, see the product information on the HP websit
.
Tape Drive Information
Select one of the tape drive entries from the Mass Storage submenu to display the following information about that
drive.
•
Status—Displays the status of the tape drive. The following values are valid:
•
OK—Indicates the tape drive is operating normally.
•
Degraded—Indicates the tape drive has degraded in some manner.
•
Failed—Indicates the tape drive has failed and can no longer return data. The tape drive may need to be
replaced.
•
Offline—Indicates the Storage Agents can no longer communicate with the tape drive. This could be caused
by a cabling problem or the tape drive may be powered off.
•
Missing - Was OK—Indicates that a tape drive that was located in a system and had a status of OK has
been removed.
Agent information 50