HP ProLiant DL380 G5 Server - Manual (Page 30)

• Pending Alarm—Displays if the alert is unable to determine the state of the iLO, or if all alerts have been
delivered or if there are alerts pending that still need to be sent.
If your system supports the Integrated Lights-Out Edition, the following alerts are available:
• Remote Insight Alerts—Allow users to enable or disable the alerts by clicking the button.
• Host Alerts allow users to enable or disable the alerts by clicking the button.
• Pending Alarm—Displays if the alert is unable to determine the state of the Remote Insight, or if all alerts have
been delivered or if there are alerts pending that still need to be sent
Battery
• Battery Status—Indicates the status of the Remote Insight board battery. When the Remote Insight board battery
is enabled and there is a host power failure, the Remote Insight board battery provides a minimum of 30
minutes of operation. This enables the Remote Insight board to send alerts to the users that were specified
during configuration.
• Battery Condition—Displays the condition of the battery. The following values are possible:
• OK—The battery is charged and functional.
• Failed—The battery needs to be replaced.
• Disconnected—The battery has been disconnected.
• Battery Charge—Displays the percentage of the charge in the Remote Insight board battery.
Power
• Auxiliary Power—Displays whether or not the auxiliary power (External Power Cable and/or Internal Power
Cable, which is a 30-pin cable or a 16-pin cable) is connected to the Remote Insight.
• Virtual Power Button—Displays whether or not the virtual power button cable is connected to the Remote Insight.
Modem/COM Port Settings
NOTE: The Modem/COM Port Settings is not supported for Integrated Lights-Out Edition or The Remote Insight Lights Out
Edition.
A series of tables is displayed providing information about any Remote Insight Board modems or communication
ports. The first table title indicates the type of device described like "Internal Modem", "External Port", "External
Modem", "External Direct Connect," or "External XonXoff". The tables may contain the following:
• Model—Displays the model of the communication device.
• Data Settings—This table contains the data settings for the communication device including:
• Alarms—Displays if the Remote Insight firmware uses this communication device to deliver traps.
• Non-PPP—Displays if non-PPP connections are allowed on this port.
• Baud Rate—Displays the baud rate to be used on this port.
• Data Bits—Displays the number of data bits to be used on this port.
• Stop Bits—Displays the number of stop bits to be used on this port.
• Parity—Displays the type of parity to be used on this port.
• Pager Settings—Displays pager settings for the communication device.
• Alarms—Displays if the Remote Insight Board firmware uses this port to deliver pages.
• Message—Displays the message that appears in the body of the page.
• Baud Rate—Displays the baud rate to use for pager messages.
• Data Bits—Displays the number of data bits to user for pager messages.
• Stop Bits—Displays the number of stop bits to use for pager messages.
• Parity—Displays the type of parity to user for pager messages.
• Modem Control Strings—This table contains the modem control strings for the communication device including
the following:
• Reset—Displays the string used to reset the modem.
• Initialize—Displays the string used to initialize the modem.
• Dial Prefix —Displays the string pre-pended to phone numbers before dialing.
Agent information 30