HP Hub & Switch Management for OV-UX - Manual (Page 22)

3-6
Introduction to HP Hub & Switch Management
What HP Devices Can Be Managed
In
tr
oduct
ion t
o
H
P
H
u
b
&
S
w
it
ch M
anageme
n
t
N o t e HP AdvanceStack hubs can be chained together on a non-network
connection called a Distributed Management Chain. For Hub & Switch
Management to access a chain of AdvanceStack hubs, at least one hub in the
chain must contain an SNMP module. Chained hubs must be of the same
media type (100VG or 10Base-T). For more information, refer to the device's
installation and reference manual.
For general management of generic SNMP devices (from HP and other
vendors), use the HP OpenView Network Node Manager functions (such as
SNMP Configuration
and SNMP MIB Browser).
HP J3301A AdvanceStack 10Base-T Hub 12M
Browser-manageable (firmware A.01.xx)
HP J3303A AdvanceStack 10Base-T Hub 24M
Browser-manageable (firmware A.01.xx)
Note 1
Optional SNMP module for HP 100 VG hubs is J2414A or J2414B
Note 2
Optional SNMP module for 10Base-T hubs is J2603A/B. HP AdvanceStack 10Base-T
hubs provided with SNMP module preinstalled include: HP J2630A (12-port), HP J2631A/B
(24-port), HP J2632A/B (48-port).
Note 3
SNMP module J3133A available for J2610B and J2611B.
Note 4
HP J2980A 10/100 LAN Switch-16 is not supported on IPX networks. To discover this
device on an IP network, the SNMP community name “public” must be configured on the
device. 100VG module J2981A and 100BaseTX module J2984A available for HP J2980A.
Note 5
No IPX Network Management support.
Note 6
Requires Management Module J3178A.
Note 7 Requires Management Module J3210A.
Note 8
No Closeup View provided. Use telnet.
Table 3-2. HP AdvanceStack and ProCurve Devices That Can be Managed