HP Hub & Switch Management for OV-UX - Manual (Page 78)

10-6
HP Hub & Switch Management Admin
HP Admin Parameters
H
P
H
u
b & S
w
it
ch
M
a
nagemen
t A
d
mi
n
The parameters are briefly described below. For more information, see the HP
Admin online help.
Network Parameters
Network parameters enable you to set values and behavior for network device
communication and Closeup View activity. The parameters for network device
communication are described in the following table.
Figure 10-1. Setting Network Parameters
HP OpenView Device Symbols
There are two states for an OpenView device symbol on an OpenView map,
explodable
and executable. When the device symbol is in the explodable
state (no box appears around it) and you double-click on it, a submap showing
Table 10-1. Network Parameters
Parameter Description
SNMP Max Retries Specifies the number of times will retry an SNMP request to
get a response. The range is 1-5 times. The default is 3.
SNMP Timeout Specifies the time (in seconds) that HP Hub & Switch
Management will wait for a reply on each request. The range
is 1-6 seconds. The default is 5.