HP Insight Management-Software - Manual (Page 80)

the bays associated with the enclosure. Click OK to create the profile and a profile list is
displayed. Click OK to accept the assignments.
2. Select Leave server profiles unassigned for now and pick the number of profiles you want
to create (up to 50). The server profile names are automatically generated based on the
server profile prefix. Click Select Location to select more bays or delete bays. Click OK
to create the profiles.
NOTE: When creating multiple server profiles, boot parameters are ignored. Edit each server
profile to specify the boot parameters.
14. Click OK. The Virtual Connect Enterprise Manager is executing the request
message appears.
15. Click OK to go to the Jobs page and monitor job progress.
NOTE: To create server profiles for Integrity Blades that boot from SAN, you must manually
configure the SAN boot entries in the blade server EFI console.
Configuring the target boot LUN
When creating or editing server profiles, you can specify a target boot LUN for the FC SAN
connections designated as Primary and Secondary in the boot priority column.
Target boot LUN values must be compliant with proper ranges.
For VC Domains, you can provide the target boot LUN in either of the following possible formats:
•
When using LUN values from 0–255, you can specify the LUN and either decimal or in 16-digit
hexadecimal number format.
•
When using LUN values greater than 255, you must specify the LUN in 16-digit hexadecimal
number format.
To specify the LUN and a 16-digit hexadecimal number format, place the desired hexadecimal
number preceded by leading zeros as shown in the following examples:
•
1023 can be represented in 16-digit hexadecimal format as 00000000000003ff or
00000000000003FF (not case-sensitive).
•
18446744073709551615 is represented in 16-digit hexadecimal format as ffffffffffffffff or
FFFFFFFFFFFFFFFF.
Configuring multiple networks
The network selection changes (selection options and Network/VLAN filters) introduced with the
VCEM 6.3.1 server profile editor apply only to VC Domain Groups running 3.3x or later. VC
Domain Groups running firmware mode earlier than 3.3x will continue to display the earlier server
profile editor.
80 Managing server profiles