HP Insight Management-Software - Manual (Page 123)

VLAN capacity) not supported by the other VC Domains (with older firmware). The VC Domain
will remain in Maintenance Mode status and VCEM will not be able to complete or cancel the
maintenance operation. To complete or cancel the maintenance operation, you must first remove
the VC Domain with Expanded VLAN capacity from the Domain Group.
No error message when assigning a profile to a server with two FlexNIC
ports on the same physical NIC
VCEM does not report an error or warning message when assigning a profile to a server with two
FlexNIC ports on the same physical NIC. To avoid this situation, see the server profile details in
the VCM GUI to verify the results of the changes you have made and ensure that you do not have
a mis-configuration.
VCM shows an incorrect address for VCEM
When you log into the Virtual Connect Manager while under VCEM control, the following message
is displayed:
VC Domain locked by Virtual Connect Enterprise Manager [x.x.x.x]
The x.x.x.x in the message is an incorrect IP address for VCEM.
NOTE: The incorrect IP address does not have any impact on VCEM management of VCM.
Leaving the incorrect IP address in place does not break any VCEM operations. The IP address is
only displayed to inform you that VCM is managed by VCEM from that IP address.
To correct the IP address in VCM, complete the following steps:
1. Verify that the Windows host where VCEM is installed has its network adapters bound in the
correct order. The network adaptor handling communications with VCM should be first in the
list. If not, re-order the network adaptors so the network adaptor handling communications
with VCM is the first one in the list.
2. Open a Windows command prompt on the VCEM host and run the following command: >
Vcem –uvcm
This command will get the IP address from the system and update all of the VC
Domains that VCEM is managing with the correct IP address.
Communicating with the enclosure OA
Although VCEM may report the VC Domain status as Managed by VCEM (green status) on the VC
Domains tab, the VC Domain might be indicating a different overall status which is not displayed
in the VCEM GUI. If the VC Domain has lost communication with the enclosure OA, Virtual Connect
Manager (VCM) reports this problem by modifying the VC Domain status. However, the VCEM
GUI does not directly report it and the only indicator for the communication issue will be one of
the following error messages displayed when VCEM is trying to communicate with VCM.
•
Error message A
The operation cannot be performed because the VC Manager has lost communication with the enclosure's
[enclosure name] Onboard Administrator (OA). This communication issue could be intermittent. Go to VC
Manager to check the status of all the enclosures associated with that VC Domain. See the Virtual Connect
user guide for more information if there is a lost communication.
•
Error message B
The operation cannot be performed because the VC Manager has lost communication with the enclosure Onboard
Administrator (OA). This communication issue could be intermittent. Go to the VC Manager to check the
status of all the enclosures associated to that VC Domain. If there is a lost communication, go to Virtual
Connect user guide to get information on how to resolve this issue.
Once VCEM returns one of the error messages above, you must go to the VCM GUI and check
the VC Domain overall status to see if it is still reporting the communication problem with the
enclosure OA and then see the HP Virtual Connect Manager User Guide to resolve the situation.
No error message when assigning a profile to a server with two FlexNIC ports on the same physical NIC 123