Vc domain tasks, Vcem licensing, Vc domain tasks vcem licensing – HP Insight Management-Software User Manual
Page 41
3.
Do not modify the SNMP configuration for VC Domain level. The default SNMP
configuration for VC Domain level is Enabled with the Community String equaling Public.
This is only available through the Virtual Connect Manager Command line interface.
•
Virtual Connect Manager 2.1x does not support the HP Virtual Connect 8-Gb 20-Port Fibre
Channel Module. Virtual Connect Manager first supported this module in Virtual Connect
Manager 2.3x. If you have this module in a VC Domain in 2.3x, VCEM will not allow you to
add this domain to a domain group running 2.1x group firmware mode.
Figure 26 Select any value other than 8Gb as uplink and downlink configuration speeds
Select any value other than 8 Gb as the downlink configuration speed when assigning a SAN
Fabric for a HP Virtual Connect 8 Gb 20-Port Fibre Channel Module.
VC Domain tasks
From the VC Domains page, you can perform the following tasks:
•
License an enclosure.
•
Create a VC Domain Group.
•
Add a VC Domain to a VC Domain Group.
•
Remove a VC Domain from a VC Domain Group.
•
Perform VC Domain maintenance.
•
Cancel VC Domain maintenance.
•
Resynchronize a VC Domain with a Configuration Mismatch status.
•
Delete a VC Domain Group
VCEM licensing
You must purchase a license for each enclosure you want to manage. For licensing information,
see the VCEM QuickSpecs at
.
To enable a VC Domain license, perform one of the following procedures:
•
For new VC Domain Groups:
1.
Click New VC Domain Group on the VC Domains page.
Both licensed and unlicensed VC domains are displayed.
VC Domain tasks
41