HP Designjet 8000 Printer series - Manual (Page 192)

Default values for media types
Your printer comes with a set of factory-installed media types. Except for media type 01, you can modify
or delete all other media types. The table below lists the default values for the factory-installed media types.
NAME PAPER (01) Glossy (02) & Matte (03) Banner (04) & BLT_B
(Backlit) (05)
MEDIA ADV. VALUE (Base) +0.00% (Base) +0.16% (Base) +0.14%
DRY TIME VALUE 0 sec. 0 sec. 0 sec.
PRINT MODE NORMAL NORMAL NORMAL
PRINT DIRECTION BIDIR BIDIR BIDIR
FLATTEN TIME None None None
USE EDGE GUARD YES YES YES
MEDIA ADV. MODE FWD ONLY FWD ONLY FWD ONLY
TUR MODE LOOSE LOOSE LOOSE
LEADING EDGE NORMAL NORMAL NORMAL
VACUUM LEVEL NORMAL NORMAL NORMAL
FRONT HEATER T None 45 °C 45 °C
PRINT HEATER T None 40 °C 40 °C
REAR HEATER T None 45 °C 45 °C
COLOR STRIPE ON ON ON
ADVANCE PREF SOFTWARE SOFTWARE SOFTWARE
BIDIRECTION DEF +00& +00& +00&
PH CLEANING START&END START&END START&END
BACK ADJUST VAL 0 0 0
PRINT MODE PREF SOFTWARE SOFTWARE SOFTWARE
HEATER PREF SOFTWARE SOFTWARE SOFTWARE
Media advance calibration
Media advance calibration is defined by using the M.ADV menu. Press the key to define and set values.
182 Chapter 14 Tell me about… (menus) ENWW
Tell me about… (menus)