HP Color LaserJet CM6030CM6040 Multifunction Printer series - Manual (Page 60)

Menu item Sub-menu item Sub-menu item Values Description
default bin for specific types of jobs such as
faxes or copies (stapler/stacker only).
Staples None
One Left Angled
One Right Angled
Two Left
Two Right
Two Top
Sets the default staple selection for
documents sent to the device when no staple
value is specified.
Staples Out Stop
Continue
Sets the default behavior when a job
specifies stapling and the stapler is out of
staples. Stop stops printing if the stapler runs
out of staples. Continue allows a job to
continue printing even when the device is out
of staples.
Offset Off
On
Turns the job offset feature on or off. When
job offset is on, each copy of a job is shifted
to one side in the output bin in order to keep
each copy separate from the others.
A4/Letter Staple Normal
Alternate 1
Alternate 2
Controls the speed of the print engine to
prevent paper jams by using the stapler
buffer.
NOTE: The stapler buffer may or may not
be used depending on the selected media
type or on the sensed media type, if
Autosense Mode is enabled.
If the Normal setting is enabled, the engine
speed will be normal by using the stapler
buffer whenever possible.
If the Alternate 1 setting is enabled, and the
engine is in Autosense Mode, the engine
slows down to prevent jams. If the product is
NOT in Autosense Mode, the engine
performs at normal speed, using the stapler
buffer whenever possible.
If the Alternate 2 setting is enabled, the
engine always slows down to prevent jams,
never using the stapler buffer.
Fold LTR-R & A4 - R –4.0 mm
–3.5 mm
–3.0 mm
–2.5 mm
–2.0 mm
–1.5 mm
–1.0 mm
Adjusts the fold line for Letter and A4 size
paper (booklet maker only).
Table 2-15 Device Behavior menu (continued)
44 Chapter 2 Control panel ENWW